Contractor L3Harris took several hours to identify the source of a network outage that caused a nationwide ground stop on a Friday, according to a person familiar with the investigation. The delay in locating the point of failure postponed the lifting of the Federal Aviation Administration (FAA) ground stop, which affected air traffic control communications and radar feeds.
The outage involved the FAA’s Federal Telecommunications Infrastructure (FTI) network, which is managed by L3Harris from an operations center in Melbourne, Florida. The network became unstable after being flooded with data attempts occurring approximately 1,000 times every four to five seconds. While the system is designed to provide real-time updates on outages, a source stated that the specific IP address causing the issue was not immediately apparent.
During the initial investigation, the FAA identified two potential sources for the disruption: Amarillo, Texas, and El Dorado, Arkansas. The agency and L3Harris eventually determined the cause was a site in Arkansas where a new router was being deployed. Transportation Secretary Sean Duffy stated on Tuesday that the company needs to perform better, specifically noting concerns that the contractor failed to identify and isolate the problem.
L3Harris responded by stating its network operations center is monitored 24 hours a day to identify latency and outages. The company noted it has been working with the FAA to modernize the National Airspace System, completing more than 70% of a transition from legacy copper wiring to fiber optics. The company stated it is supporting the FAA’s investigation into the outage.
The incident has drawn scrutiny of L3Harris, which manages critical infrastructure for the FAA. With 30% of the fiber optic conversion still pending, Secretary Duffy stated that the contractor's failure to identify and isolate the issue is a concern. The FAA is conducting an investigation into the conditions that caused the outage.